Cisco Antennas (53 products)
Single Band 2.4 GHz Omnidirectional ISA100 Antenna, 5 dBi
The Cisco Aironet 1550 Series Outdoor Mesh Access Point for Hazardous Locations (hereafter called the access point or AP) is a modularized wireless outdoor access point designed for use in a mesh network. The access point also supports wireless client access, point-to-point bridging, point-to-multipoint bridging, and point-to-multipoint mesh wireless connectivity. More Info
Four-Port Dual-Band Polarization-Diverse Antenna, 2.4-2.5/5.15-5.925 GHz, 13...
Cisco Aironet Four-Port Dual-Band Polarization-Diverse AntennaThis document describes the AIR-ANT2513P4M-N antenna and provides electrical specifications and mounting instructions. The antenna is a four-port polarization-diverse patch array that operates over the 2.4-GHz and 5-GHz Wi-Fi bands. It ships with an articulating mount for use on flat surfaces and masts and is adjustable in both the horizontal and vertical planes. The radome is paintable using commonly available non-conductive spray paints, such as Krylon or Rust-Oleum. The antenna... More Info
Two radios (4x4:3 5 GHz and 4x4:3 2.4 GHz) with External Antennas, AC, DC, or...
The Cisco Aironet 1570 Series Outdoor Access Point (hereafter called the access point or AP) is a wireless outdoor access point which is designed for use in a variety of network configurations. The access point can be configured, monitored, and operated through a Cisco wireless LAN controller (hereafter called a controller). The controllers use a browser-based management system, a command-line interface (CLI), or the Cisco Prime Infrastructure (PI) network management system to manage the controller and the associated access points. The... More Info
2.4 GHz/5GHz, 50 Ohms, 4-dBi/7-dBi, N-Male, IP66, IP67, Grey, Spare
This describes the Cisco Aironet AIR-ANT2547VG-N dual-band omni-directional antenna, and provides specifications and mounting instructions. The antenna is designed for outdoor use with Cisco Aironet Outdoor Access Points (hereafter referred to as access points) with radios operating in the 2.4 GHz and 5 GHz frequency bands. More Info
3W, 50ohm, TNC male, 2dBi
The 4G-LTE-ANTM-D omnidirectional dipole antenna is designed for indoor use with Cisco 4G and Cisco 3G wireless Integrated Services Routers Generation 2 (ISRs G2) and Enhanced High-Speed WAN Interface Cards (EHWICs).The 4G-LTE-ANTM-D antenna is marked with a green band and the product ID (PID) to indicate that it supports 4G Long Term Evolution (LTE) networks. It has the following hardware features: - Articulating Joint—It can be rotated 360 degrees and is capable of maneuvering into three stop positions: 0 degrees, 45 degrees, and 90... More Info
Multiband Panel Outdoor 4G Antenna
Multiband Panel Outdoor 4G Antenna More Info
2.4GHz 6dBI, 5GHz 8dBI
Cisco Aironet Dual-Band Omnidirectional Antenna (AIR-ANT2568VG-N) is designed for outdoor use with Cisco Aironet Outdoor Access Points (hereafter referred to as access points) with radios operating in the 2.4-GHz and 5-GHz frequency bands.Installation NotesThe antenna is designed to connect to a dedicated antenna port on the access point. No special tools are required to install the antenna.The antenna is resistant to the full range of outdoor environments. After the antenna is attached to the access point, seal the connections to prevent... More Info
4G LTE, GPS, 1W, 1.5dB, 50Ohm, 50GSMA male
The Cisco 4G indoor/outdoor, active GPS antenna (GPS-ACT-ANTM-SMA) can be physically connected to the Cisco Integrated Services Routers (ISRs) and Cisco 4G Enhanced High-Speed WAN Interface Cards (EHWICs) to receive GPS broadcasts from satellites. More Info
4G-LTE-ANTM-O-3-B - 698-960 MHz / 1710-2700 MHz
Indoor or outdoor low-profile antenna with 4-foot dongle, black radome.4G-LTE-ANTM-O-3 antenna is an integrated 3-in-1- indoor and outdoor antenna. It comes with two Long Term Evolution (LTE) antennas and one Global Positioning System (GPS) antenna in a single radome. More Info
Omni, 2.4/5GHz, 2.9/3.7dBi, RP-TNC
The Downtilt Panel Omnidirectional antenna is ideal for medium ceiling (8 ft - 25 ft) aesthetic consensus installations. Some example uses are medium-density deployments like cube office space and vestibules. This antenna supports Meraki’s smart antenna capabilities. The price shown is for a 5-connector model; the Downtilt Panel Omni antenna can be purchased with 5 or 6 connectors. More Info
Dipole, 2.4/5GHz, 3.8/5.5dBi, RP-TNC
The Dipole antenna is ideal for low ceiling installations where wall penetration or extended reach are important. Some example uses are low-density deployments like schools and hotels to provide basic low-performance connectivity. These types of best effort deployments usually have APs installed in the hallway to cover adjacent rooms. More Info
Dipole, 2.4/5GHz, 3.8/5.5dBi, RP-TNC
The Dipole antenna is ideal for low ceiling installations where wall penetration or extended reach are important. Some example uses are low-density deployments like schools and hotels to provide basic low-performance connectivity. These types of best effort deployments usually have APs installed in the hallway to cover adjacent rooms. More Info
Dipole, 2.4/5GHz, 3.8/5.5dBi, RP-TNC
The Dipole antenna is ideal for low ceiling installations where wall penetration or extended reach are important. Some example uses are low-density deployments like schools and hotels to provide basic low-performance connectivity. These types of best effort deployments usually have APs installed in the hallway to cover adjacent rooms. More Info
Dipole, 2.4/5GHz, 3/5.7dBi, RP-TNC
The Dipole antenna is ideal for low ceiling installations where wall penetration or extended reach are important. Some example use cases are low-density deployments like schools and hotels to provide basic connectivity. These types of best-effort deployments usually have APs installed on walls or uneven surfaces. This antenna is bendable. More Info
Dipole, 2.4/5GHz, 3/5.7dBi, RP-TNC
The Dipole antenna is ideal for low ceiling installations where wall penetration or extended reach are important. Some example use cases are low-density deployments like schools and hotels to provide basic connectivity. These types of best-effort deployments usually have APs installed on walls or uneven surfaces. This antenna is bendable. More Info