Green mode

Patent-pending operating mode that bypasses unused electrical components in good power conditions to achieve very high operating efficiency without sacrificing any protection.



Battery failure notification

Provides early-warning fault analysis on batteries enabling timely preventive maintenance



Power-saving outlets

Automatically cuts power to idle equipment to conserve electricity.



Resettable circuit breaker

Easy recovery from overloads; no need to replace a fuse.



Extendable Run Time

Additional batteries can be added to provide power to the load for an extended period of time in the event of utility supply failure.



Battery-protected and surge-only outlets

Reserves power capacity and run time for connected equipment that require battery back-up while providing surge only protection for less critical equipment



Cold-start capable

Provides temporary battery power when the utility power is out.



Serial Connectivity

Use any Home Automation network to monitor and control the S20 through its RS-232 serial port. For information on how to communicate with the S20, see APC's Application Note #102. Crestron and AMX installers should visit their respective websites for information on how to integrate the S20 into those networks.



Hot-swappable batteries

Ensures clean, uninterrupted power to protected equipment while batteries are being replaced



Disconnected battery notification

Warns when a battery is not available to provide backup power.



Dataline Surge Protection

Provides protection of connected equipment from power surges on the data lines.



Automatic self-test

Periodic battery self-test ensures early detection of a battery that needs to be replaced.



Adjustable voltage-transfer points

Maximizes useful battery life by widening the input voltage window or tightening the output voltage regulation.